Splendide WDC1024M Washer/Dryer User Manual


 
Page 10
HOW TO USE YOUR NEW WASHER
-
DRYER
Load the drum with clothes as previously described.
Close the door.
Select a program. See cha
rt below/11.
Select drying time (and half heat if required).
Select desired spin speed (high spin only occurs in
regular wash cycle).
Put the detergent, bleach and fabric conditioner into
the dispenser.
Press the ON
-
OFF button to start th
e machine.
Note:
Woolen garments should under no circumstances
be tumble dried.
TUMBLE
-
DRY
If you want to tumble dry a load wi
thout washing, rinsing
or spinning, proceed as follows:
Note:
The dry weight of the load must not exceed
requirements pre
viously mentioned.
Make sure that the power cord is plugged in and that
circuit is energized.
Make sure that the wash timer kn
ob is at an OFF
-
DRY
position.
Press the Half Heat button, if you wish to dry at a low
temperature.
Set the Dryer Timer knob to
the drying time you
require.
Open the door, load the articles to be dried into the
cylinder and close the door.
Press the On/Off button in and the machine w
ill then
start the drying cycle.
Door may be opened during drying cycle.
TO RINSE, SPIN AND TUMBLE
-
DRY
It is possible to rins
e, spin and tumble
-
dry articles which
have not been previously washed in the machine. The dry
weight of the load must not exceed
load size previously
described.
Make sure that the power cord is plugged in and that
the circuit is energized.
Open the hot an
d cold water taps fully.
Load the machine with the articles to be rinsed.
If you wish, put fabric conditioner in the additives
compartment "D" of the Detergent Dispenser (For
WDC1024M compartment “C”).
Turn the program selector knob to the position mark
ed
"Rinse". Select the desired heat setting. Press the half
heat if you want a low dry temperature. Set the dryer
timer to the d
esired time.
Select the desired spin speed. High speed spin only
occurs in the regular cycle.
Switch the machine on by pressin
g the ON/OFF
button.
WASHING TABLE
MODELS WDS1043M
-
SWD1054M
-
WDC1024
-
WDC1024M