Filter
Top Products
GB 13
Description of red indications
Red indication lamp
lights up
Indication on display
(if fitted on your
machine)
Description
Causes
Solutions
“Water tap closed”
Appliance has no or insufficient water supply. The
“Start/Pause”
light flashes.
Check whether:
•
Water tap is fully open and water supply pressure
is sufficient.
•
Kinks are present in water inlet hose.
•
Mesh filter of water supply hose is blocked (see
“Care and Maintenance”.
•
Water hose is frozen up.
•
Safety valve inspection window of your water
supply hose is red (provided your appliance has a
water supply hose as shown on picture
“A”
- see
previous chapter “Care and Maintenance”);
replace the hose by a new one available through
our After-Sales Service or your specialist dealer.
After problem has been removed, restart
programme by pressing
“Start/Pause”
. If the fault
occurs again, contact our After-Sales Service (see
next chapter).
“Clean pump”
Waste water is not pumped out. The appliance
stops in the corresponding programme step; unplug
it and check whether:
•
Kinks are present in the drain hose.
•
Filter or pump is blocked (see chapter “Cleaning
the Filter/ Draining Residual Water”;
make sure
the water has cooled before draining the
appliance)
.
•
The drain hose is frozen up.
After problem has been removed, select and start
“Drain” programme or push “Reset” button for at
least 3 seconds; afterwards restart desired
programme. If the fault occurs again, contact our
After-Sales-Service (see next chapter).
IFU-TL HR GB.fm Page 13 Thursday, February 15, 2007 3:35 PM
Black process 45.0° 100.0 LPI