Filter
Top Products
SM1634
16
INSTALLING THE MACHINE
(ACCORDING TO MODEL)
For transport purposes the swinging unit in the machine is blocked using 4
spacers with screws. Before starting the machine these spacers and lock screws
must be removed, and stored for use in the event of a possible change of
location.
Block off the holes with the plugs provided, which can be found in the bag
containing the documents.
N.B. If the spacers fall into the inside of the machine, open the rear panel,
recover them and then replace the panel.
For transport purposes the swinging unit in the machine is blocked using 4
spacers with screws. Before starting the machine these screws must be re-
moved using a screwdriver.
Insert a screwdriver in the holes and proceed as shown in the figure to recover
the 4 plastic spacers.
N.B. If the spacers fall into the inside of the machine, open the rear panel,
recover them and then replace the panel.
The machine must be installed by professionally qualified technicians, according to
the manufacturer’s indications. Incorrect installation may result in damage to per-
sons and property.
The machine can be installed anywhere, provided the temperature in the place of
installation is not below 3°C and the cables and hoses at the rear of the machine are
not crushed in any way.
V
2
3A
2A
3
GB