Smeg S800TL1 Washer/Dryer User Manual


 
GB 3
FIRST WASH CYCLE
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
1.Packing
The packaging materials are 100% recyclable
and bear the recycling symbol . Adhere to
local regulations when disposing of packaging
material.
2.Energy saving tips
Achieve the best use of energy, water, detergent
and time by using the recommended maximum
load size.
Do not exceed the detergent dosages indicated
in the manufacturer’s instructions.
The Eco Ball - a special system in the outlet - will
prevent detergent loss from the drum to avoid
detergent loss into the environment.
Use “Prewash” for heavily soiled laundry only!
Save detergent, time, water and energy
consumption by not selecting “Prewash” for
slight to normally soiled laundry.
Pretreat stains with stain remover or soak dried
in stains in water before washing to reduce the
necessity of a hot wash program.
Save energy by using a 60°C instead of a 90°C
wash programme or a 40°C instead of a 60°C
wash programme.
Save energy and time by selecting a high spin
speed to reduce the water content in laundry
before using a tumble dryer (for machines with
adjustable spin speed).
3.Disposing of packaging and old washing
machines
The washing machine is built from reusable
materials. The washing machine must be
disposed of in compliance with current local
waste disposal regulations.
Before scrapping, cut of the power cable so that
the washing machine cannot be connected to the
mains.
Remove detergent from compartment if you
intend scrapping your washing machine.
4.Child safety
Children must not be allowed to play with or in
the washing machine.
5.General recommendations
Do not leave the washing machine connected
when not in use. Turn off the tap.
Before cleaning or carrying out maintenance
switch off the washing machine and disconnect it
from the mains supply.
To clean the outside of the washing machine, use
a neutral detergent and a damp cloth.
Do not use abrasive detergents.
Do not attempt to force the lid open.
If necessary, the power cable may be replaced
with an identical one obtained from our After-
Sales Service. The power cable must only be
replaced by a qualified technician.
6.EC Declaration of Conformity
This washing machine has been designed,
constructed and distributed in compliance with
the safety requirements of EC Directives:
73/23/EEC Low Voltage Directive
89/336/EEC EMC Directive
93/68/EEC CE Marking Directive
We recommend that the first wash cycle be carried out empty. This will remove any residual water used
in the factory checks.
1.
Turn on the tap.
2.
Close the drum flaps.
3.
Pour a small amount of detergent (about 30 ml) into the detergent dispenser .
4.
Select a short programme (see programme chart).
5.
Switch on the machine.
6.
Press the
“On/Off”
button.
6GB10055.fm Page 3 Monday, August 2, 2004 12:33 PM