Smeg AS 73 CS Clothes Dryer User Manual


 
5 - EN
2 Installation
Refer to the nearest Authorised Service
Agent for installation of your product.
CPreparation of location and electrical
installation for the product is under
customer’s responsibility.
BInstallation and electrical connections
must be carried out by a qualified
personnel.
APrior to installation, visually check if
the product has any defects on it. If
so, do not have it installed. Damaged
products will cause risks for your
safety.
Appropriate installation locati-
on
• Install the product in an environment
which has no risk of freezing and is in a
stable and level position.
• Operate your product in a well
ventilated, dust-free environment.
• Do not block the air ducts in front of
and under the product with materials
such as long pile rugs and wooden
bands.
• Do not place your product on a long
pile rug or on similar surfaces.
• Do not install the product behind a
door with a lock, sliding door or a
hinged door which can strike the
product.
• Once the product is installed, it should
stay at the same place where its
connections have been made. When
installing the product, make sure
that the rear wall of it does not touch
anywhere (tap, socket, etc.) and also
pay attention to install the product at a
place where it will stay permanently.
BDo not place the product on top of the
power cable.
• Keep at least 1.5 cm distance to walls
of other furniture.
Ventilation hose and connecti-
on (for products equipped with
an outlet vent)
Ventilation hose allows exhaust air from
inside the machine
Vented dryer has 1 air outlet.
Stainless sheet metal or aluminum pipes
can be used instead of a hose. The pipe
diameter should be minimum 10 cm.
Maximum hose and pipe lengths are
given in the table below.
Hose Pipe
Maximum length
4 m 5 m
1 elbow 45°
-1.0 m -0.3 m
1 elbow 90°
-1.8 m -0.6 m
1 elbow 90° short
-2.7 m
1 wall passage
-2.0 m -2.0 m
CEach elbow and other passages should
be subtracted from the maximum
length stated above.
To connect a ventilation hose;
1. Connect the air outlet hose to the
hose spacer piece by turning it
counterclockwise.
2. Make the hose passages as shown
below.
CExhaust of humid air from the dryer
into the room is inconvenient. It may
damage the walls and furniture in the
room.
CThe ventilation hose can be routed
outdoors via a window or it can be
connected to the air outlet in the
bathroom.
CAir outlet hose must be routed directly
to the outdoors. There must be a
limited number of elbows as not to
hinder ventilation.
CTo prevent water accumulation in the
hose, make sure that it is not folded on
the floor.