Sears 64291 Washer User Manual


  Open as PDF
of 4
 
FEATURES
E1 Lint Screen
Keep the lint screen clean. A lint-clogged screen will slow down the flow
of air. This makes drying time longer and wastes energy. Clean the lint
screen before each load as follows:
!. With dryer off, remove the screen by pulling straight up.
2. Roll the dry lint off the screen. Do not wet the screen or lint; wet lint is
hard to remove.
3. Replace the cleaned lint screen.
_Yir_!i_JlXe]
Fire Hazard.
Do not use your dryerwhile the lint screen isremoved.
It could cause overheating and possible damage to fabrics and dryer
parts or create a fire hazard. Lint screen must be pushed firmly into
place.
NOTE: If lint screen gets clogged by detergent orfabric softener build-up,
remove and clean it with a nylon brush, hot water and liquid detergent.
Dry and replace screen.
E1 Safety Door Switch
For safety, the switch shuts off dryer when door is opened. Dryer will not
start until door is closed and START is pushed. Be sure the Cycle Selector
Control is on a dry setting.
[[3 Performance Guide Label
Located inside the dryer door. Gives information on what to do if dryer
does not perform normally.
NOTE: If dryer drum is stained, clean it with a damp cloth and mild
detergent.
l_l Model No. Plate
Shows model and serial numbers. Have these ready if you ever call for
service.
!
Formore detailed drying times, rules for safe operation, fabric care, |
maintenance and installation information, refer to the LAUNDRY
I
GUIDE and INSTALLATION INSTRUCTIONS you rex_ivedwith
your dryer.
II I
Part No. 3392338 Printed in U.S.A.
 previous