Filter
Top Products
4 SAMSUNG Washing Machine Owner’s Instructions
Connecting the water supply hose
The water supply hose must be connected to the washing machine at one end and to
the water faucet at the other. Do not stretch the water supply hose. If the hose is too
short and you do not wish to move the water faucet, replace the hose with a longer,
high pressure hose.
To connect the water supply hose:
1. Take the L-shaped arm fitting for the cold
water supply hose and connect to the cold
water supply intake on the back of the
machine. Tighten by hand.
2. Connect the other end of the cold water supply hose to your sink's cold water faucet
and tighten it by hand. If necessary, you can reposition the water supply hose at the
washing machine end by loosening the fitting, rotating the hose, and retightening the
fitting.
Option:
1. Take the red L-shaped arm fitting for the hot water supply hose and connect to the
red hot water supply intake on the back of the machine. Tighten by hand.
2. Connect the other end of the hot water supply hose to your sink's hot water faucet
and tighten it by hand.
3. Use a Y-piece if you only want to use cold water.
Note: The appliance is to be connected to the water mains using new hose-sets and
that old hose-sets should not be used.
Positioning the drain hose
The end of the drain hose may be positioned in three ways:
Over the edge of a sink
The drain hose must be placed at a height
of between 60 and 90 cm. To keep the drain
hose spout bent, use the supplied plastic hose
guide. Secure the guide to the wall with a
hook or to the faucet with a piece of string to
prevent the drain hose from moving.
ln a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the hose is at least
60 cm above the ground.
ln a drain pipe
Samsung recommends that you use a 65 cm high vertical pipe; it must be no shorter than 60
cm and no longer than 90 cm.
Installing the Washing Machine
WF-J145NC-02211A-GB.indd 4 2006-03-29 ｿﾀﾀ・10:42:29