Filter
Top Products
SAMSUNG Washing Machine Owner’s Instructions D-1
Problems and solutions
The washing machine will not start
• Make sure the door is firmly closed.
• Make sure the washing machine is plugged in.
• Make sure the water source faucet is turned on.
• Make sure to press the Start/Pause button.
No water or insufficient water supply
• Make sure the water source faucet is turned on.
• Make sure the water source hose is not frozen.
• Make sure the water intake hose is not bent.
• Make sure the filter on the water intake hose is not clogged.
Detergent remains in the detergent drawer after the wash programme is
complete
• Make sure the washing machine is running with sufficient water pressure.
• Put the detergents in the inner parts of the detergent drawer(away from the outside edges).
Washing machine vibrates or is too noisy
• Make sure the washing machine is set on a level surface. If the surface is not level, adjust the
washing machine feet to level the appliance.
• Make sure that the shipping bolts are removed.
• Make sure the washing machine is not touching any other object.
• Make sure the laundry load is balanced.
The washing machine does not drain and/or spin
• Make sure the drain hose is not squashed or bent.
• Make sure the water hose mesh filter is not clogged.
The Door does not open
1. Disconnect the power plug from the power supply.
2. Remove the water from the washing machine.
3. Open the filter cover using a coin.
4. Locate the orange plastic tab and pull forward to open the door.
; Except 800rpm models as WF7758S6(W/V/S/C/R),WF7658S6(W/V/S/C/R),WF7528S6(W/
V/S/C/R),WF7458S6(W/V/S/C/R)
5. The door will not open until 3 minutes after the machine stops or the power turns off.
; Only 800rpm models as WF7758S6(W/V/S/C/R),WF7658S6(W/V/S/C/R),WF7528S6(W/
V/S/C/R),WF7458S6(W/V/S/C/R)
Understanding error messages
Error displayed Solution
door/dE
• Close the door.
4E
• Make sure the source water faucet is turned on.
• Check the water pressure.
5E
• Clean the debris filter.
• Make sure the drainage hose is installed correctly.
UE
• Laundry load is unbalanced; loosen any tangled laundry.
If only one item of clothing needs washing, such as a bathrobe or jeans, the
final spin result might be unsatisfactory and an “UE” error message will be
shown in the display window.
cE / 3E
• Call after-sales service.
Before contacting After-Sales service:
1. Try to remedy the problem (See “Troubleshooting” on this page).
2. Restart the programme to see if the fault is repeated.
3. If the malfunction persists, call after-sales service and describe the problem.
Troubleshooting
WF7750S6-02376K-01_EN.indd 1 2007-08-24 ¿ÀÀü 11:06:44