Filter
Top Products
maintaining your washer _35
PURE CYCLE
TM
Pure Cycle is a self-cleaning cycle that removes mold that may occur inside the washing machine.
1. Press the Power button.
2. Press the Pure Cycle
TM
button.
• Once the Pure Cycle button is pressed, the only
function that can be set is Delay Start.
3. Press the Start/Pause button.
• If you press the Start/Pause button, Pure Cycle
begins.
• Using Pure Cycle, you can clean the drum without using a cleansing agent.
• Never use Pure Cycle when laundry is in the washing machine. This may cause damage to
the laundry or a problem with the washing machine.
• If you want to use drum cleansing agent, use only 1/10 of the amount of the drum
cleansing agent recommended by the cleansing agent manufacturer. (When using a
powder-type cleansing agent , remove the liquid detergent compartment.)
The Pure Cycle Auto Indicator Function
• If the “Pure Cycle” button is lit after a wash, it indicates
that tub (drum) cleaning is required. In this case, remove
the laundry from the washing machine, turn the power on,
and clean the drum by running Pure Cycle.
• If you do not run Pure Cycle, the “Pure Cycle” indicator
turns off. However, the “Pure Cycle” indicator will light
again after two washes. Not running Pure Cycle at this
point will not cause a problem with the washing machine.
• Although the Pure Cycle Auto Indicator appears once a
month or so, the frequency may differ depending on the
number of times the washing machine is used.
04 maintaining your washer
CAUTION
WF435A-03159B-02_EN_20120829.indd Sec4:35WF435A-03159B-02_EN_20120829.indd Sec4:35 2012-08-31 12:33:042012-08-31 12:33:04