Samsung WF365BTBGWR Washer User Manual


  Open as PDF
of 132
 
16_ setting up your washer
INSTALLING YOUR WASHER
Before STEP 5 is complete, do not plug the power cord into a wall socket.
Packaging materials can be dangerous to children; keep all packaging material (plastic bags,
polystyrene, etc.) well out of the reach of children.
Installation flow chart
Selecting a
location
Finish the
installation
Removing the shipping
bolts (*Drum only)
Connecting the water
and the drain
Adjusting the
levelling feet
Powering your washing
machine
[Running a test cycle]
Run a test cycle (Rinse+Spin) with
small amount of laundary
(about 4~5 Towels)
Yes
Please
check again
before
steps.
No
Does
your washer
have excess vibration
or noise?
STEP 1
Selecting a location
Before you install the washer, make sure the location:
• Hasahard,levelsurfacewithoutcarpetingorflooringthatmayobstructventilation.
• Hasnodust,oil,detergentetc.
• Isawayfromdirectsunlight.
• Hasadequateventilation.
• Willnothavetemperaturesatorbelow32˚For0˚C.
• Isawayfromheatsourcessuchasoilorgas.
• Hasenoughspacesothatthewasherdoesn’tstandonitspowercord.
STEP 2
Removing the Shipping Bolts
Before using your washer, you must remove all shipping
bolts from the back of the unit.
1. Loosen all the bolts with the supplied wrench.
2. Slide the bolt and spacer up and remove the bolt with
the spacer through the hole in the rear wall of your
washer. Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the shipping bolts and spacers for future use.
setting up your washer
WARNING
CAUTION
 previous next