Samsung WF350AN-02833B-01 Washer User Manual


 
30_ troubleshooting and information codes
PROBLEM SOLUTION
Fills with the wrong
temperature water.
 Turn both faucets on fully.
 Make sure the temperature selection is correct.
 Make sure the hoses are connected to the correct faucets.
Flush water lines.
 Check the water heater. It should be set to deliver a minimum
120°F(49°C) hot water at the tap. Also check the water heater
capacity and recovery rate.
 Disconnect the hoses and clean the screens. The hose filter screens
may be plugged.
 As your washer is filling, the water temperature may change as
the automatic temperature control feature checks incoming water
temperature. This is normal.
 While your washer is filling, you may notice just hot and/or just
cold water going through the dispenser when cold or warm
wash temperatures are selected. This is a normal function of the
automatic temperature control feature as your washer determines the
temperature of the water.
Door locked or will not
open.
 Press the Start/Pause button to stop your washer.
 Your washer door will remain locked during the heating portion of the
Sanitize cycle.
 It may take a few moments for the door lock mechanism to
disengage.
Does not drain and/or spin.  Check the fuse or reset the circuit breaker.
 Straighten the drain hoses. Eliminate kinked hoses. If there is a drain
restriction, call for service.
 Close the door and press the Start/Pause button. For your safety,
your washer will not tumble or spin unless the door is closed.
Load is too wet at the end
of the cycle.
 Use the High or Extra High spin speed.
 Use high efficiency detergent to reduce over–sudsing.
 Load is too small. Very small loads (one or two items) may become
unbalanced and not spin out completely.
Leaks water.  Make sure the door is firmly closed.
 Make sure all hose connections are tight.
 Make sure the end of the drain hose is correctly inserted and secured
to the drainage system.
 Avoid overloading.
 Use high efficiency detergent to prevent over–sudsing.
Has excessive suds.  Use high efficiency detergent to prevent over-sudsing.
 Reduce the detergent amount for soft water, small or lightly soiled
loads.
 Non-HE detergent is NOT recommended.
troubleshooting and
information codes
WF350AN-02833B-01_EN.indd 30 2010-10-13 �� 10:20:31