Samsung WF220 Washer User Manual


 
setting up your washer _15
INSTALLING YOUR WASHER
STEP 1
Selecting a location
Before you install the washer, make sure the location:
Has a hard, level surface without carpeting or flooring that may obstruct ventilation.
Has no dust or alien substances.
Is away from direct sunlight.
Has adequate ventilation.
Will not be freezing (below 32 ˚F or 0 ˚C).
Is away from heat sources such as oil or gas.
Has enough space so that the washer doesn’t stand on its power cord.
STEP 2
Removing the Shipping Bolts
Before using your Washer, you must remove the four shipping bolts from the back of the unit.
1. Loosen all the bolts with the supplied wrench.
2. Slide the bolt and spacer up and remove the bolt with
the spacer through the hole in the rear wall of your
washer. Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the shipping bolts and spacers for future use.
01 SETTING UP YOUR WASHER
WF210AN-02832A_EN.indd 15 2010-02-09 ø¿»ƒ 1:14:58