Filter
Top Products
22_ Troubleshooting
High/Low voltage detected. Restart the cycle.
If the code reappears, call for service.
SilverCare™ control problem Restart the cycle.
If the code reappears, call for service.
Too many suds are detected
during the washing session.
The unit is put on hold until the
suds are reduced. Then, the unit
will go back to the operation.
When it finishes washing, End and
SUdS codes will blink in turn.
To prevent it, cut down on detergents.
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
troubleshooting
WF337A-02440A-05_EN.indd 22 2007-04-17 ø¿»ƒ 1:53:34