Filter
Top Products
- 12 -
■ HOW TO ADD THE FABRIC SOFTENER
■ HOW TO PUT THE DETERGENT IN
1. Open the detergent box by pulling in the direction of the arrow as shown in
the figure and then put the powder detergent in the detergent box.
2. Put in one-time amount of detergent evenly so the detergent may not brim
over the box.
CAUTION : If softener is stored over the above base line, it may flow down at
any time.
■ WATER SUPPLY CONNECTOR FILTER
■ CLEANING THE FILTER
Clean the filter net often to keep the washer clean.
■ HOW TO CLEAN THE PUMP FILTER
• When a proper amount (one time does) of fabric softener is
stored in the softener inlet, it is automatically put in at the last
rinsing cycle.
• Do not use detergent, bleach or starch into the Softener Inlet.
• Using too much softener may produce
unsatisfactory results.
• Do not open the lid during the Spin Dry cycle. If
added too early, its effectiveness will decrease.
• Do not leave the softener into the Softener.
Dispenser for a long time. Because softner
became stiff.
1. Pull out the filter and
wash well.
2. Pull in the filter and
connect the hose to the
inlet water valve tightly.
3. Check if there is a
leakage.
Note to tighten up
the connector.
Detergent Device
Put the
detergent in proportion
to Water level
Softener
baseline
Softener Device
••••••••••
••••••••
••••••••••••••••••••
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
inlet water
valve
1. Push the upper part of the Magic
filter and pull in.
1. Push up and pull out the filter net.
2. Open the cover as shown in the
figure.
2. Remove the collected lint from the
filter net.
3. Clean the Magic filter. 3. Clean the filter net.
4. Close the cover and insert the
lower part of the filter in the
basket first and then push the
filter with “click” sound.
4. Pull down the filter net.
1. Place a rag under the washer filter not to
wet the floor.
2. Rotate the filter counterclockwise and pull
out the filter.
3. Remove dirts and rotate the filter clockwise
until it locks in position.