Samsung WA400PJHDWR Washer User Manual


  Open as PDF
of 60
 
ALIGNMENT AND ADJUSTMENTS
7
Service Mode
Service Mode:
1.ThewashermustbeontogointotheServiceMode.
2.Themotorspeedwillbedisplayedwhenstarted(Itdisplays0whenthemotordoesnotspin).
3.Thepresentstateofthemachinewillnotbechanged.
(i.e.,thecurrentcycleinprogresswillnotbeinterruptedandonlythedisplaywillchange)
4. ToexitServiceMode,pressDelayStartandAquaJet
TM
(WA456*),ExtraRinse(WA422*/WA400*)
Keysfor3secondagain,orPowerKey.IfnokeyisoperatedduringServiceModefor5minutes,
themachinewillreturntonormalusermode.
Quick Spin Test Mode
Denition of Quick Spin Test Mode:
- QuickSpinTestModeistodoSpinCheck.(HighRPM)
How to Enter:
- DuringServiceMode,presstheDelayStartandEcoPlus(WA456*)/PreSoak(WA422*,WA400*)
Keysfor3secondstoenterQuickSpinTestMode.
- Cannotenteroncethewashingcyclehasstarted.
Quick Spin Test Mode:
AsitentersintotheQuickSpinTestMode,itstartsspinningandreachestoitsmaximumRPM.
OncetheSpinspeedreachesthemaximumRPM,thespeeddropsimmediately.
ToholdQuickSpinTestMode(enteringHoldSpeedMode),presstheStart/Pausebutton.Ifthe
Start/PausebuttonispressedduringQuickSpinTestMode,itwillstopacceleratingandholdits
spinningspeedfor10minutesbeforegoingbacktoQuickSpinTestMode.
Also,tocanceltheholdandallowQuickSpinTestModetocontinue,presstheDelayStartandEco
Plus(WA456*)/PreSoak(WA422*,WA400*)Keystogetherfor3seconds.
IfyouholddowntheDelayStartandEcoPlus(WA456*)/PreSoak(WA422*,WA400*)keysforthree
(3)secondswhenthewashingmachineisnotinHoldSpeedMode,QuickSpinModeisexitedand
ServiceModeisrestored.
Toavoidriskofelectricalshock,personalinjuryordeath;disconnectpowertowasher
beforeservicing,unlesstestingrequirespower.
WARNING
TM
Delay Start and AquaJet (WA456*)/
Extra Rinse(WA422*/WA400*)
Delay Start + Eco Plus(WA456*)/
Pre Soak(WA422*,WA400*)
While it is not in Hold Speed Mode
Delay Start + Eco Plus(WA456*)/
Pre Soak(WA422*,WA400*)
3 sec
While a cycle is not running
Delay Start + Eco Plus(WA456*)/
Pre Soak(WA422*,WA400*) for 3 sec or
after 10 minutes
 previous next