Filter
Top Products
5
CLEANING THE FILTER NET
1.Push the upper part of
the filter and pull in.
2.Open the cover as
shown in the figure.
3.Clean the filter. 4. Close the cover and insert the lower
part of the filter in the basket first and
then push the filter with "click" sound .
●
When a proper amount of fabric softener is stored in the
box, it is automatically added in at the final rinse cycle.
❈
In case the hot water only is connected, this function will
not be operated.
HOW TO ADD THE DETERGENT
HOW TO ADD THE FABRIC SOFTENER
1. Open the detergent box by pulling in
the direction of the arrow as shown in
the figure.
2. Add the amount of detergent for one
washing evenly in the box so that the
detergent does not overflow the box.
❈
When too much softener is stored above the base line, it
may not be operated properly.
1. Place a rag under washer filter not to wet the floor.
2. Turn the filter-cap to the left.
3. Take out the filter and remove any sludge.
4. Reassemble in reverse order.
CLEANING THE FILTER
(pump drained washer)
SEE IF THE MACHINE IS PLACED LEVEL BY
CHECKING THE POSITION OF THE WASHING TUB.
●
Open the lid of the machine, pour water into the tub up to
the level just below the pulsator, and adjust the legs so
that the pulsator is positioned at the center of the water as
shown in the figure.
●
Place the machine more than 10cm away from the wall.
LEVELLING
Adjustment the heigt of the machine
Adjust the legs to level the washer
Be careful not to put in your hand under the legs.
Pull the handles located at the
right and left of the front side and
slide off.
Adjust the height of the machine
upward or downward.
When the adjustment is finished,
push the handles to fix the
adjusting legs.
Water