Filter
Top Products
5
HOW TO CLEAN THE FILTER CLEANING THE FILTER (pump drained washer)
Clean the filter net often to keep the washer clean. 1. Place a rag under washer filter not to wet the floor.
2. Turn the filter-cap to the left.
3. Take out the filter and remove any sludge.
4. Reassemble in reverse order.
HOW TO ADD THE DETERGENT
1. Open the detergent box
by pulling in the direction of the
arrow as shown in the figure.
2. Add the amount of detergent for one
washing evenly in the box so that the
detergent does not overflow the box.
LEVELLING
1. Pull down the adjusting handles of
the adjusting feet which are located
at the right and left of the front side.
2. Adjust the height of the
machine upwards or downwards.
3. When the adjustment is finished,
push back the handles to fix the
adjusting feet.
Note
Do not kick or step on the adjusting
handles.
HOW TO ADD THE FABRIC SOFTENER
When a proper amount of fabric softener is stored
in the box, it is automatically added in at the
final rinse cycle.
In case the hot water only is connected,
this function will not be operated.
When too much softener is stored above the
base line, it may not be operated properly.
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING
THE POSITION OF THE WASHING TUB.
Open the lid of the machine, pour water into the tub
up to the level just below the pulsator, and adjust the
legs so that the pulsator is positioned at the center of
the water as shown in the figure.
Place the machine more than 10cm away from the
wall.
1. Push the upper
part of the filter
and pull in.
2. Open the cover
as shown in the
figure.
3. Clean the filter. 4. Close the cover and
insert the lower part
of the filter in the
basket first and then
push the filter with
"click" sound .
SW68ASP-02290A-EN.indd 5 2006-08-21 ¿ÀÈÄ 8:33:13