Filter
Top Products
SAMSUNG
Washing Machine Owner’s Instructions 11
Washing clothes manually
You can wash clothes manually without using the Fuzzy Logic feature. To do so:
1. Turn on the water at the water source sink.
2. Press the (On/Off) button on the washing machine.
3. Press the Door Open button. (S1005J, S805J)
Note: You cannot open the door until you press (On/Off).
4. Open the door.
5. Load the articles one at a time loosely into the drum, without overfilling.
6. Close the door.
7. Put the detergent and, if necessary, softener or prewash detergent, in the appropriate
compartments.
8. Press the Temperature button to select the temperature
(cold water, 30˚C, 40˚C, 60˚C, 95˚C)
9. Press the Spin button to select the spin speed, [no, rh, 400, 600, 800, …, no, …
revolutions per minute(rpm)].
Note: The rinse hold program allows you to take clothes that are dripping wet out of
the washing machine.
no : No Spin, rh : Rinse Hold.
10. Repeatedly press the Wash, Rinse or Option button to select the cycle you prefer:
Prewash (for Baby Cotton, Cotton, Colour, Synthetic, Delicate only), Water
+
,
Rinse
+
, Eco
+
, Soak wash.
11. Press the Start/Pause button and the machine will begin the cycle.
When the cycle is finished:
1. Press the Door Open button. (S1005J, S805J)
Note: The door will not open until 3 minutes after the machine stops or
the power turns off. (S1003J, S803J)
2. Remove laundry.
Using Delay Start (S1005J, S1003J, S805J, S803J)
You can set the washing machine to start your wash automatically at a later time, choosing
from a 1 to a 24 hour delay (in 1 hour increments).
To do this:
1. Manually or automatically set your washing machine for the type of clothes you are
washing.
2. Press the Delay Start button repeatedly until the delay time is set.
3. Press the Start/Pause button. The Delay Start indicator will light, and the clock will
begin counting down until it reaches your start time.
4. To cancel Delay Start, press the (On/Off) button, then turn the washing machine on
again.
Washing a Load of Laundry