Samsung r1031gws Washer User Manual


 
12
7. General Error Function
When an error occurs, this function starts to keep generating error melody sounds and displays error indicators as
shown in the followings per corresponding error by blinking in 0.5sec interval until the error status is completely cleared out.
In this case, all the driving devices are turned off until the error is cleared out.
1. WATER SUPPLY ERROR
- Display shows such as fig. 1
- Water Supply Error occurs when water level frequency does not show
changes more than 100Hz or water is not supplied
up to the water level presetting for 20 min or more at the time of initial
water supply.
-The error status can be cleared by turning POWER S/W OFF and
resuming the POWER ON initial status.
2. WATER DRAIN ERROR
- Display shows such as fig.2
- In case the water level frequency is 24.5KHz or less in the initial phase
of UNB-detecting cycle.
- Water Drain error can be cleared by turning POWER S/W OFF and
resuming the POWER ON initial status.
3. OVER-FLOW ERROR
- Display shows such as fig.3
- Over-Flow error occurs when the water level is in abnormal operation.
ItcanbeclearedbyturningPOWERS/WOFF.
Water is drained prior to POWER S/W OFF and it is forced to be drained
for 2 min if a frequency of more than 24.5 KHz is detected.
4. UNBALANCE ERROR
- Display shows such as fig4.
- Laundry load is unbalanced; loosen any tangled laundry.
- If only one item of clothing needs washing, such as a bathrobe or jeans,
the final spin result might be unsatisfactory and an error message will be
shown in the display panel such as fig 4..
- Unbalance error is cleared by POWER S/W OFF and by resuming the
POWER ON initial status.
5.WATERHEATERERROR
- Display shows such as fig.5 or fig.6
- In case the water temperature rises by 7C or more in 1 min. or by 2C
less in 10 min after heating is started.
- It can be cleared by turning POWER S/W OFF.
6 DOOR OPEN ERROR
- Display shows such as fig.7
- Door Open error can be cleared by closing the door.
7. ASSí Y PRESSURE S/W ERROR
* Generated Frequency Signal of WATER LEVEL(W/L) S/W (KHz)
Level Low Level High Level
Abnormal W/L Frequency 30.00 KHz 15.00 KHz
:Lighton
:Lightoff
fig. 1
fig. 2
fig. 3
fig. 4
fig. 5
fig. 6
fig. 7