Filter
Top Products
Unpacking the Washing Machine
Unpack your washing machine and inspect it for shipping damage. Also make sure that you have received all of the
items shown below. If the washing machine was damaged during shipping or you do not have all of the items, con-
tact your Samsung dealer immediately.
Overview of the washing machine
Selecting a location
Before you install the washing machine, select a location with the following characteristics:
• A hard, level surface (if the surface is uneven, see "Adjusting the leveling feet," below)
• Away from direct sunlight.
• Adequate ventilation
• Room temperature that will not fall below 0˚C
• Away from sources of heat such as coal or gas Make sure that the washing machine does not stand on
its power cord. Ventilation openings must not be obstructed by carpeting when the washing machine is
installed on a carpeted floor.
Adjusting the leveling feet
If the floor is uneven, adjust the feet (do not insert pieces of wood or any other objects under the feet):
1. Loosen the leg bolt by turning it with your hand until it is at the desired height.
2. Tighten the locking nut by turning it with the wrench.
• Place the washer on a sturdy, flat surface.
If the washer is placed on an uneven or weak surface,
noise or vibration occurs.
(Only a 1 degrees angle is allowed.)
3
Cover top
Base cover
Adjustable feet
Debris filter
Door
Detergent
drawer
Control panel
Bolt hole
covers
Plug
Cold Water
supply hose
Drain Hose
Installing the Washing Machine
J1453-01999L-GB-0610.indd 3J1453-01999L-GB-0610.indd 3 2005-06-10 ¿ÀÈÄ 5:25:312005-06-10 ¿ÀÈÄ 5:25:31