Filter
Top Products
5
WASHING PROCEDURE
Before starting washing, check the following;
Connect the water supply hose to the water tap. Leave a tap
open. Plug the power cord in. Make sure to lay down the
drain hose. (In case no drain pump)
Put the laundry into the washer and add detergent, too.
Be careful not to overload. Use right detergent
for the fabrics you are washing.
FUZZY COURSE
Selects the best washing course
automatically.
1. Press the POWER Button to"ON".
2. Press the START/HOLD button.
Water level is selected automatically.
Washing,rinsing, and spinning follow.
If you want to pause, press the START/HOLD
button again.You can change the course when paused.
3. Close the lid.
BLANKET COURSE
1. Press the power button to "ON".
2. Press the course select
button once.
3. Press the START/HOLD button
Water level is selected automatically.
Washing, rinsing, and spinning follow.
If you want to pause, press the START/HOLD
button again.You can change the course when paused.
4. Close the lid.
SPEEDY COURSE
1. Press the power button to "ON".
2. Press the course select button twice.
3. Press the START/HOLD button
Water level is selected automatically.
Washing, rinsing, and spinning follow.
If you want to pause, press the START/HOLD
button again.You can change the course when paused.
4. Close the lid.
WOOL COURSE
1.Press the power button to "ON".
2.Press the course select three times.
3.Press the START/HOLD button.
Washing,rinsing, and spinning follow.
If you want to pause, press the START/HOLD
button again.You can change the course
when paused.
CAUTION . . .
-Do not use water above 30˚C for WOOL washing.
-Refer to the tag attached on the clothes for washing
information.
-Fasten buttons and turn inside out before washing.
-Use the detergent indicated in the laundry.
-When the degree of dirt is extreme, soak the laundry in warm
water for about 10 minutes before pressing the WOOL course
button in order to enhance washing efficiency.
4. Close the lid.
THOBE COURSE
1.Press the power button to "ON".
2.Press the course select three times.
3.Press the START/HOLD button.
Water level is selected automatically.
Washing,rinsing, and spinning follow.
If you want to pause, press the START/HOLD
button again.You can change the course
when paused.
4. Close the lid.
DELAY START COURSE
Select this course when you have to go out or do
something else.
1. Press the power button to "ON".
2. Press the DELAY START button once.
You may change the delay start time with
use the DEALY START button.
(from 3 hours to 18 hours)
3. Press the START/HOLD button and put
the proper amount of detergent into tub.
4. Close the lid.
The washing finishes by the time you
reserved.
POWER
COURSE
COURSE
START/
HOLD
START/
HOLD
POWER
COURSE
START/
HOLD
POWER
POWER
START/
HOLD
DELAY
START
POWER
COURSE
START/
HOLD
POWER
START/
HOLD
gb-ar-8kg-01518Q 6/5/02 1:22 PM Page 6