Filter
Top Products
Operating Instructions
All drying programs end with a 5 or 10 minute cooling phase. Following this, if the
laundry is not removed then at the end of the cycle the dryer will perform an anti
creasing phase. The duration of the anti creasing phase is approximately 30 minutes.
If you do not remove the laundry , the dryer will stop automatically at the end of the
anti-creasing phase. The ‘End’ light will illuminate and the buzzer will sound for 15
seconds, if it has been selected, at the end of the phase. Turn the programme
selector dial to ‘0’ and all lights will go out.
If the drying program is stopped before the end of the program, it’s suggested the
dial is turned to ‘warm to wear’ then wait until the machine has completed the
cooling phase before removing the laundry. This avoids a build up of heat inside the
appliance. To do this, first turn the dial to ‘0’ and then rotate the dial to ‘warm to
wear’ and press the start button.
To change a program that has already started, firstly cancel it by rotating the dial to
‘0’. Then select the desired programme and press the start button.
Important , after each use make sure the filter is cleaned.
12
For Customer Services & Spare Parts please call 0845 208 8750
Opening times: Monday - Friday 9am – 5pm & Saturday 9am – 1pm or visit
us at www.productcareuk.com
Display
The duration of the drying cycle is displayed in hours and minutes. This time is
calculated automatically unless the time setting is selected. The remaining time to
the end of the cycle counts down in minute intervals.
Indicator lights
This light comes on as a reminder to clean the condenser. It is
recommended to clean the condenser three or four times per
year.
This light comes on when the water container is full, try to empty
the water container after every load.
This light comes on as a reminder to clean the filter, it is
recommended to clean the filter after every load. The drying
efficiency of the machine will deteriorate if the filter is not
cleaned.