Filter
Top Products
6
Filling the water tank
˾
Remove cap, fill the tank with ordinary
tap water and close the cap.
Replacing the water tank
˾
Put the full water tank back into the
unit, by sliding the lower handle back into
the top half of the handle until it is firmly in
place.
Adding water during use
˾
Always unplug the appliance and wait for it to cool down before
removing the water tank.
˾
Handle with care as unit will remain hot for a considerable time.
˾
Fill as indicated in water tank filling section.
˾
Plug in the appliance and wait approximately one minute to ensure
your Steam 'n Press is fully reheated before using it.
ATTACHING AND REMOVING THE SOLEPLATE COVER
Attaching the soleplate cover
The Steam 'n Press should be unplugged and completely cool when
removing or attaching the soleplate cover.
˾
To attach the soleplate cover (K) to
the Steam 'n Press, hold the soleplate cover
by the ribbed finger grips (J) and slide the
cover over the soleplate.
˾
Turn the soleplate cover lock (G) half a
turn (180°) to the left to lock the soleplate
cover into position.
˾
Your appliance can be used as a Steambrush once cover is attached.
Reference “Steambrush Function“ section of instructions for further
use information.