Filter
Top Products
7
Caring and Cleaning
Iron
1. Turn Temperature Control Dial to Off (O). Unplug and let
cool. The iron takes longer to cool down than it does to
heat up.
2. To empty water from iron, slowly tilt pointed end of iron
down over a sink. Water will run out of water tank opening.
3. Wrap cord loosely around iron and store iron in an upright
position. Do not store iron laying flat on soleplate.
Soleplate
1. Never iron over zippers, pins, metal rivets, or snaps, as
these may scratch the soleplate.
2. To clean occasional build-up on the soleplate, wipe with
a sudsy cloth. Do not use abrasive cleansers or metal
scouring pads.
3. Always store iron upright in the heel rest position.
Self-Clean
To keep the steam vents clear of any build-up, follow these
instructions each time you iron using steam.
1. Turn Temperature Control Dial to OFF ( O ) and set
Adjustable Steam Switch to Dry Iron . Fill iron with water
to 1⁄2 of its maximum capacity.
2. Turn Temperature Control Dial to Linen setting and let iron
heat for 2 minutes in the heel rest position. Keep
Adjustable Steam Switch on Dry Iron .
3. Turn Temperature Control Dial to OFF (O). Unplug iron and
hold over a sink with soleplate facing down.
Features
6
Auto Shutoff Reset Button
This light comes on when the iron is first
plugged in. After 15 minutes, the iron will
shut off and the light will go out. Push the
Reset Button to turn the iron back on for
another hour of ironing.
Power ON Light and
Auto Shutoff Light
This light comes on when the iron is
plugged in and remains on until the iron
is unplugged. The light stays on even if
Temperature Control Dial is turned to Off.
This light also functions as the Auto
Shutoff Light.
Spray and Blast of Steam Buttons
Push Blast Button for an extra blast of
steam. Do not press Blast Button more
than every 5 seconds. Push Spray Button
to release a fine spray
of water for difficult
wrinkles in cotton or linen.
840158400 Ev02.qxd 1/3/07 11:09 AM Page 6