Filter
Top Products
1 Always unplug cord from electrical outlet and set the Steam
Control to position 0.
2 Fill the removable water reservoir to the maximum level.
Do not use vinegar or other descaling agents to self clean your iron.
3 Plug cord in electrical outlet.
4 Set the Temperature Control to MAX.
5 Allow iron to heat up for two minutes.
6 Turn Temperature Control to Min and unplug iron when the
Amber Pilot Light has gone out.
7 Hold the iron over the sink,press and hold the self-clean
button and gently shake the iron.
4
Steam and boiling water will come out of the soleplate. Impurities and
scale (if any) will be flushed out.
8 Release the self-clean button as soon as all the water in the
reservoir has drained out.
Repeat the self-cleaning process if the iron still contains a lot of
impurities.
After self-cleaning
- Plug in the iron and reheat for 2 minutes.This will enable interior of
the iron to dry before storing.
- Unplug the iron when the Amber Pilot Light has gone out.
- Move the hot iron gently over a piece of used cloth to remove any
water stains that may have formed on the soleplate.
- Let the iron cool down completely before you store it.
Maintenance and Storage
1 Set the Temperature Control to Min position. Unplug cord
from electrical outlet and let the iron cool down completely.
2 Wipe scale and any other deposits off the soleplate with a
damp cloth and a non-abrasive (liquid) cleaner.
Keep the soleplate smooth: avoid hard contact with metal objects.
3 Regularly rinse the removable water reservoir with water.
Empty the removable water reservoir after cleaning or before
storing.
7
Shot of Steam
This function can also be used when you hold the iron in vertical
position.
A powerful "shot" of steam helps remove stubborn creases.
The Shot-of-Steam function can only be used at temperature settings
between and MAX.
1 Press and release the Shot-of-Steam button.
Wait for a while before using the button again to avoid spluttering.
Never direct the steam towards people.
Anti-Calc Filter
◗ The built-in Anti-Calc Filter reduces deposit of scale and helps
prolong life of the iron.
Auto-off
An electronic safety device will automatically switch off the iron if it has
not been moved for a while.
◗ To indicate that the iron has been switched off,the Red Auto-
Off Pilot Light will start blinking.
In a horizontal position, this will happen after 30 seconds.
In a vertical position, this will happen after 8 minutes.
To heat up the iron again:
- Pick up the iron or move it slightly.
- The Red Auto-Off Pilot Light will go out.The Amber Pilot Light will
come on.
- When the Amber Pilot Light has gone out and comes on again, the
iron is ready for use.
sELF-Self-Cleaning
The self-clean function removes scale and impurities.
Use the self-clean function once every two weeks. If the water in your
area is very hard, the self-clean function should be used more
frequently.
6
HI478/IRON.FA 1/13/00 2:35 PM Page 10