Philips GC3115 Iron User Manual


 
Important
Read these instructions for use carefully before using the appliance and
save them for future reference.
Check if the voltage indicated on the type plate corresponds to
the local mains voltage before you connect the appliance.
Check the cord regularly for possible damage.
Do not use the appliance if the plug, the cord or the appliance
itself is damaged.
If the mains cord is damaged, it must be replaced by Philips, a
service centre authorised by Philips or similarly qualified persons
in order to avoid a hazard.
Never leave the iron unattended when it is connected to the
mains.
Never immerse the iron in water.
Keep the appliance out of the reach of children.
The soleplate of the iron can become extremely hot and may
cause burns if touched. Do not allow the cord to come into
contact with the soleplate when it is hot.
When you have finished ironing, when you clean the appliance,
when you fill or empty the water tank and also when you leave the
iron even for a short while: set the steam control to position 0, put
the iron on its heel and remove the mains plug from the wall
socket.
This appliance is intended for household use only.
Before first use
C
1 Remove any sticker or protective foil from the soleplate.
2 Let the iron heat up to maximum temperature and pass the
iron over a piece of damp cloth for several minutes to remove
any residues from the soleplate.
B
The iron may give off some smoke when you use it for the first time.This
will cease after a short while.
Preparing for use
Filling the water tank
Never immerse the iron in water.
1 Make sure the appliance is unplugged.
C
2 Set the steam control to position 0 (= no steam).
3 Open the cap of the filling opening.
4 Tilt the iron backwards.
ENGLISH4