Filter
Top Products
ALCOVE OR CLOSET INSTALLATION
12
60 sq. in.
(387.1 sq. cm)
60 sq. in.
(387.1 sq. cm)
Closet door
Installation Instructions
WASHER CONNECTIONS FOR STATIONARY MODELS
WSLS1100 AND WSLM1100 (CONT.)
RUN THE WASHER THROUGH A
COMPLETE CYCLE
7
Check for water leaks and proper operation.
REMOVE THE PROTECTIVE FILM
COVERING THE CONTROL PANEL
8
It contains valuable and helpful information that will
save you time and money.
READ THE REST OF THIS
OWNER’S MANUAL
9
NOTE: If your washer does not operate, please review
the Before You Call For Service section.
If your washer is approved for installation in an
alcove or closet, there will be a label on the back
of the machine describing requirements.
• Minimum clearances between washer and adjacent
walls or other surfaces are: 0″ either side, 2″ front,
3″ rear.
• Minimum vertical space from floor to overhead
shelves, cabinets, ceilings, etc. is 96″.
• Closet doors must be louvered or otherwise
ventilated and have at least 60 square inches open
area for washer only, or if the closet contains both
a washer and dryer, doors must contain at least
120 square inches of open area equally distributed.
NOTE: The clearances stated on this label are
minimums. Consideration must be given to
providing adequate clearances for installation
and servicing.
INSTALLATION CHECKLIST
6
Before starting the washer, check to make sure:
❏ Main power is turned on.
❏ The washer is plugged in.
❏ The water faucets are turned on.
❏ The unit is level.
❏ The drain hose is properly tied up.
❏ There are no leaks at the faucet, drain line
or washer.