Filter
Top Products
Step 1 Select cycle
5
Controls at a glance
DRYEL FABRIC CARE (select models)
is designed for use on dry clean only fabrics
in combination with Dryel Dry Clean Only
Fabric Care product. Placing the control dial
arrow at the DRYEL line will provide the
optimal amount of time needed to properly
use Dryel. (For more information on using
the Dryel cycle, see page 7.)
WRINKLE RELEASE will release wrin-
kles from items that are clean and dry but
slightly wrinkled, such as from a crowded
closet, packed suitcase or from sitting in the
dryer too long after the end of the cycle. It
provides 10 minutes of heated tumbling and
5 minutes of cool down tumbling without
heat.
DAMP DRY is designed to “partially” dry
items. It provides approximately 20 minutes
of heated tumbling and 5 minutes of cool
down tumbling without heat.
INTELLIDRY REGULAR automatically senses the moisture
in the load and shuts off when the selected dryness level is
reached. This cycle is designed for loads such as towels, under-
wear, t-shirts, jeans, etc. Set the control to the desired dryness
level (MORE DRY – LESS DRY). The line between MORE DRY
and LESS DRY is the initial preferred setting for the majority of
loads.
INTELLIDRY WRINKLE FREE FABRICS WITH PRESS
CARE
automatically senses the moisture in the load and shuts
off when the selected dryness level is reached. It minimizes wrin-
kles in synthetic fabrics such as acrylic, nylon, polyester or blends
by providing an unheated cool-down period at the end of the cycle.
Simply set the control to the desired dryness level (MORE DRY –
LESS DRY). The line between MORE DRY and LESS DRY is the
initial preferred setting for the majority of loads.
TIME DRY/AIR FLUFF may be select-
ed for any load if the IntelliDry sensor sys-
tem is not used. Set the control to the
desired number of minutes and choose the
appropriate drying temperature for the load.
Control features and styling vary by model.
The dial can be turned in either direction to select a cycle. Once started, the dial will not advance at a specific rate during the
IntelliDry cycles. At first the dial may not advance at all.Toward the end of the cycle (when the load begins to dry) the dial will
advance at a more regular rate and much more quickly.This is normal operation.
NOTE