Filter
Top Products
55
FILLING
AA
1 Make sure that the iron is not
plugged in and then set the
variable steam control
‹‹
to the
‘0’ position before filling the iron
with water.
2 Open the fill cap and pour water
through the filling hole
››
into
the water tank
··
, using the
beaker provided, one beaker full
of water fills the tank (400ml).
AA
After filling replace the fill cap. In
hard water areas the use of
distilled or demineralised water
is recommended.
Never use battery topping up
fluid or water containing any
substances like starch, or sugar,
or defrosted water from a
refrigerator.
3 Always pour out the remaining
water after use. Warning: When
filling your iron with tap water
always use the beaker provided.
Never fill directly under the tap.
Temperature
control
BB
Plug in the iron and switch on.
The ‘power on’ indicator lights
„„
situated in the back cover
will illuminate. Set the
temperature control dial
BB
to
the temperature required, but
don’t start ironing immediately. If
you wait a few minutes, the iron
will stabilise at the required
setting. Your Morphy Richards
iron is fitted with an indicator
light
‡‡
which will go on and off
while you are ironing.
This is perfectly normal as it
shows that the iron is
maintaining the heat setting you
have chosen.
It is always a good idea to begin
with cool fabrics and work up to
higher settings.
An iron heats up quicker than it
cools down so you’ll save time
and electricity.
FEATURES OF YOUR
IRON
Temperature
indicator light
The indicator light under the
control knob shows that the iron
is warming up. When the
required temperature is reached
the light will go out and will
cycle on-off during operation.
Dry ironing
You can use your iron as a dry
iron only. Make sure the variable
steam control
‹‹
is set to the ‘0’
symbol.
Any temperature setting may be
used depending on the
garment. The spray feature may
be used provided there is water
in the tank (see filling section).
You do not need to put any
water in the tank when dry
ironing only.
Spray
CC
Press the spray button
¤¤
and
aim the spray of water at
stubborn creases. You can do
this whilst dry ironing providing
there is water in the tank. When
using the water spray it may be
necessary to push the button a
few times to get the spray pump
primed.
Variable steam
DD
Fill the iron with water as
described in ‘Filling’, page 4 and
insert the plug into the electrical
socket.
The steam output can be varied
from low to high by sliding the
variable steam control
DD
. When
using the iron at the bottom of
the steam range, the steam
output should be adjusted to
the lowest setting.
The steam facility should only
be used on garments which are
suitable for ironing at 2 and 3
dot setting.
A
Min
Max
Silk
Nyl
on
W
oo
l
C
otton Linen
BB
CC
DD
lower
steam
2 dot
higher
steam
3 dot