Filter
Top Products
4
Locate the steam generator horizontally on the
iron rest plate of your ironing board (if large
enough) or on a heat resistant stand at the same
height as your ironing board or below it. Always
ensure the steam generator is on a firm surface
when ironing.
WARNING: Do not use the product on a
surface which could be damaged by heat or
steam such as a worktop or a polished wood
surface.
If in doubt, contact Morphy Richards.
Remove any protective cover from the soleplate
(4) and the base unit, if any.
Unwind and straighten the power cord
(24) and
steam supply cord (23).
Textiles and clothes should carry ironing
instructions. If not, follow the temperature guide
above, but test the temperature by ironing the
hem of the garment or similar discreet area first.
It is advised to begin with ‘cool’ fabrics and work
up to higher settings. An iron heats up quicker
than it cools down so you’ll save time and
electricity.
If you turn the temperature dial down from a hot
setting to a cooler setting, wait until the iron
temperature has stabilised before you continue
ironing.
NOTE: Hold the base with both hands when
handling and moving the unit, as the water tank is
detachable.
Location
Before use
Heat setting markings on the temperature dial of all Morphy Richards irons match those of the International
Textile Care Labelling Code
Temperature guide
Symbol
(120°C Max) Cool (160°C Max) Warm (210°C Max) Hot MAX setting
Control dial
positions
Do not iron
• •• •••
Fabric Nylon, Acetates,
synthetic fabrics
Wool, Polyester
mixtures
Cotton, Linen
Rayon, Rayon
mixtures
Ironing Iron on wrong side,
if moisture
required, use
damp cloth
(not Acetate)
Fabrics requiring
this setting usually
require steam
pressing.
Steaming
Without steam
Steam level setting
(see step 4 of
‘Using the Steam
Generator for
steam ironing’ on
page 5)
No steam
(see ‘Dry ironing’
on page 6)
Low Medium / High High
RN42221MUK Rev4_IB 02/07/2013 15:22 Page 4