Filter
Top Products
No drip system (certain models only)
Your iron is fitted with a no drip system
which is designed to prevent water escaping
from the soleplate when the iron is too cold.
During use, the no drip system may emit
a loud click, particularly during heat-up or
whilst cooling down. This is perfectly normal
and indicates that the system is functioning
correctly.
Auto shut-off
(certain models only)
If your iron is fitted with the auto shut-off
function it will automatically shut down after
a set period.
If the iron is left unattended in the
horizontal position it will shut down after 30
seconds.
If it is left in the vertical position it will
shut down after 8 minutes. When this
happens the two ‘power on’ lights, situated
in the back cover „ will flash to show that
the iron is in power-off mode.
To reactivate the iron gently shake it until
the ‘power on’ lights „ stop flashing and
remain on.
The iron will then start to heat back up to
the temperature it is set to.
Life long anti-scale
system
(certain models only)
The life long anti-scale system reduces
scale deposits and helps prolong the life of
the iron.
Emptying and storing
When you have
finished ironing,
unplug your iron.
Ensure that the
variable steam control
is set at the ‘0’
position, lift up the fill
cap and empty any
remaining water out of the filling hole.
Do not store in the box, but in an upright
position, so that any drops of water
remaining cannot leak out and discolour the
soleplate.
IMPORTANT: The flex can
be damaged if wound too
tightly around the iron after
use. Make a loose loop with
the flex and wrap it around
the iron. The iron must be
cool before winding the flex
and storing on its heel.
Maintenance
Jet cleaning
Your iron has a built in cleaning system
designed to keep the water valve, steam
chamber and steam vents clear of lint and
loose mineral deposits. The ‘jet clean’ should
be operated after each period of ironing.
To operate, ensure that there is little water
in the tank, place the iron on its heel and turn
the temperature control dial to the maximum
setting. Wait for the temperature indicator
light to go out, then unplug the iron and hold
it about 6’’ (150mm) above the sink in the
ironing position. Press the shot of steam
button about 10 times in succession. After
this cleaning operation, empty out any
remaining water.
WARNING: Do not attempt to descale
the soleplate with descaling products.
6
turbo steam RN40655 Rev 1 23/7/04 1:34 PM Page 6