Filter
Top Products
6
Steam off
‘MAX’ steam
D
E
Variable steam
Fill the iron with water as
described in ‘Filling’, page
4, and insert the plug into
the electrical socket.
The steam output can be varied
from low to high by turning the
variable steam control D. When
using the iron at the bottom of
the steam range, the steam
output should be adjusted to
the low setting.
The steam facility should only
be used on garments which are
suitable for ironing at 2, 3-dot
and MAX setting.
Shot of steam
E
Press the shot of steam
button ¤ to obtain a burst
of extra steam for ironing
out creases in heavy
material such as denim etc.
The shot of steam can be used
whilst dry ironing, providing
there is water in the tank, and
the temperature control is set
within the steam range.
Do not use shot of steam at
temperatures below the steam
range shown on the control dial.
Note: For optimum steam
quality, do not operate the shot
more than three times in
succession.
Vertical steam
Hold the iron in a vertical
position between 1cm and 2cm
away from the item F. Press the
shot of steam button ¤, this will
create vertical steam. This
feature is especially useful for
removing creases from hanging
clothes, curtains, wall hangings,
etc.
Note; For optimum steam
quality, do not operate the shot
more than three times in
succession.
No drip system
Your iron is fitted with a no drip
system which is designed to
prevent water escaping from the
soleplate fl when the iron is too
cold.
During use, the no drip system
may emit a loud click,
particularly during heat-up or
whilst cooling down. This is
perfectly normal and indicates
that the system is functioning
correctly.
Life long anti-scale
system
The life long anti-scale system
reduces scale deposits and
helps prolong the life of the iron.
MAINTENANCE
Self cleaning
G
Your iron has a built in cleaning
system designed to keep the
water valve, steam chamber and
steam vents clear of lint and
loose mineral deposits.
1 Half fill the iron with water.
2 Place the iron on its heel.
3 Connect to a mains supply
outlet.
4 Set the temperature control to
‘MAX’. See ‘Temperature
control’ on page 5.
5 The temperature indicator light
will illuminate while the iron is
heating up until the required
temperature is reached.
6 The temperature indicator light
will turn off when the selected
temperature is attained.
7 Disconnect the iron from the
mains supply outlet.
8 Hold the iron horizontally over a
sink.
9 Press and hold down the
Self-Cleaning button ‡.
UK Helpline 0844 871 0953 Replacement Parts 0844 873 0719 Ireland Helpline 1800 409 119
F
RN40743 MUK Rev6:40715 rev3 27/03/2009 14:18 Page 6