Filter
Top Products
55
Temperature
control
BB
Plug in the iron and switch on.
Set the temperature control dial
‰‰
to the required temperature,
but don’t start ironing
immediately.
If you wait a few minutes, the
iron will stabilise at the required
setting. Your Morphy Richards
iron is fitted with a temperature
indicator light
··
which will go
on and off while you are ironing.
This is perfectly normal as it
shows that the iron is
maintaining the heat setting you
have chosen.
It is always a good idea to begin
with cool fabrics and work up to
higher settings.
An iron heats up quicker than it
cools down, so you’ll save time
and electricity.
FEATURES OF YOUR
IRON
Temperature indicator
light
The indicator light
··
shows
that the iron is warming up.
When the required temperature
is reached, the light will go out
and will cycle on-off during
operation.
Dry ironing
You can use your iron as a dry
iron only. Make sure the variable
steam control
››
is set to the ‘0’
symbol.
Any temperature setting may be
used depending on the
garment. The spray feature may
be used, providing there is water
in the tank (see the ‘Filling’
section on page 4). You do not
need to put any water in the
tank when dry ironing only.
Spray
CC
Press the spray button
flfl
and
aim the spray of water at
stubborn creases. You can do
this whilst dry ironing, providing
there is water in the tank. When
using the water spray, it may be
necessary to push the button a
few times to get the spray pump
primed.
Variable steam
DD
Fill the iron with water
(as described in the
‘Filling’ section on
page 4) and insert the
plug into the electrical
socket.
The steam output can be varied
from low to high by moving the
variable steam control
DD
. When
using the iron at 2 dot, the
steam output should be
adjusted to the low setting.
The steam facility should only
be used on garments which are
suitable for ironing at 2 and 3
dot setting.
Shot of steam
EE
Press the shot of
steam button
fifi
to
obtain a burst of
extra steam for
ironing out creases
in heavy material
such as denim etc.
The shot of steam can be used
whilst dry ironing, providing
there is water in the tank, and
the temperature control is set
within the steam range.
Do not use the shot of steam at
temperatures below the steam
range shown on the control dial.
Note: For optimum steam
quality, do not operate the shot
more than three times in
succession.
BB
CC
DD
EE
55
Lower steam
Higher steam
40704 rev2 30/7/08 16:04 Page 5