Filter
Top Products
Produktgruppe: 19 Umbau- und Montageanweisung
4 von 6 M.-Nr. 05353262
08.07.2004 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden, Eigentumsrechte vorbehalten.
Reason
The washer-dryer stack kits WTV 421 and WTV 423 are for washing machines W 1203, W 1213 or W 1215 in combination
with dryers T 1403 or T 1405.
Parts required
Fitting instructions
Washing machine lid and lid holder removal, Fig. 1
- Remove the screw caps.
- Loosen the lid screws with approx. 5 turns and press them in to release the retaining clips.
- Lift the lid at the front, slide it to the rear and remove it.
- Remove the screws from the two rear lid holders.
- Slide the holders to the side and remove them.
Fitting washer-dryer stacking kit on washing machine, Fig. 2
- Push the shelf slightly in to release it. Pull out the shelf to its end stop. Lift the shelf slightly and pull it forwards. Tilt the
shelf downwards and remove it.
- Lay the stacking kit in position on the washing machine and align it with the appropriate holes.
- Secure the stacking kit on the washing machine casing at the rear with 2 raised head screws M 4 x 11 and toothed
washers and at the front with 4 raised head screws M 4 x 11.
- Refit the shelf.
Dryer feet adjustment, Fig. 3
- Adjust the dryer feet so that they protrude by 13/16 inch (= 20 mm).
- Turn the front dryer feet such that a edge faces the front (the corners are then at the right and left).
Washer-dryer stack assembly, Fig. 4
- Fit the dryer on the washing machine in its guides and slide the feet into their retaining slots.
- Insert the retaining pieces and secure them with raised head screws M 4 x 12.
Fitting fascia edge on shelf, Fig. 5
- Slide the fascia from above into its retainers.
USA
Quantity Mat. no. Designation
1 06046660 Washer-dryer stack kit WTV 421 GHWS
1 06051960 Washer-dryer stack kit WTV 423 EDST
Danger!
Before any service work is performed, the machine must be positively disconnecting the power supply by removing the
plug from the wall receptacle.
Even with the machine switched off, power voltage may be applied to some components.
Note
Service and repair work should only be carried out by an authorized qualified technician in accordance with all applicable
local and national safety regulations.
Servicing, modification, testing and maintenance of electrical appliances should only be carried out in accordance with
all applicable safety requirements, accident prevention regulations and valid standards.
Note
Empty the condensed water container before continuing the installation.
Danger!
Carry out appropriate electrical safety checks.