Filter
Top Products
Reminder to remove transport bars
,
To avoid the risk of damage, the
transport bars must be removed
before the machine is used for the
first time. See "Installation and
connection" for instructions on how
to do this.
^
After removing the transport bars (if
this has not already been done by
your fitter) press the OK button.
Running your first programme
Your machine is now ready for the first
programme to be run.
15:00
Select programme
^ Turn the programme selector to
Cottons.
^ Open the stopcock.
^
Press the Start/Stop button.
^
At the end of the programme switch
the machine off.
After running the first programme, the
load sensor has to be calibrated to
zero as you would with bathroom
scales.
Calibrating the load sensor to zero
^
Switch on the washing machine.
^
Open the drum door.
^
Turn the programme selector to
Cottons.
^ Press and hold the Load/Detergent
button pressed in until the following
message appears in the display:
:
Zero setting OK
^
Switch off the washing machine.
The washing machine is now ready for
use.
Before using for the first time
14