Filter
Top Products
Installation site
,
Do not install the dryer in an area
where it can be blocked, e.g. behind
a door.
Transporting the dryer to the
installation site
The rear excess end of the lid has a
handle box for transport.
^
Use the front dryer feet and the rear
excess end to transport the dryer
from the packaging base to the
installation site.
Installation beneath a counter
,
When the machine lid needs to
be removed to reduce the height of
the machine, a built under spacer
kit* is necessary.
It must be installed by a Miele
Service Technician.
The cover plate of the built under kit
replaces the appliance lid and
ensures electrical safety.
An installation manual is supplied with
the built-under spacer kit.
The electrical connection should be
near the dryer and accessible at all
times.
Extended machine feet* are
recommended at a built-in height of
more that 33
1
/
16
" (840 mm).
^ Set the extended machine feet on a
height of 1
9
/
16
" (40 mm).
Remove the original machine feet
and replace them with the extended
ones.
One or two filler frames* are
recommended at a niche height of
34
1
/
4
"/34
13
/
16
"to36"/36
5
/
8
"
(870/885 - 915/930 mm).
* (optional accessory)
An existing continuous toe kick must
be interrupted at the dryer location!
Reinstallation of the machine lid
When reinstalling the appliance lid,
check the firm fit of the cover at the rear
bracket for a safe transport of the dryer.
Installation
31