Filter
Top Products
Adjusting the dryer's
electronics for very soft water
,
Extremely soft water can affect
the sensitivity of the control
electronics. If the dryer is installed in
an area with very soft water, you
should contact your local water
supplier for information and advice
regarding water hardness and water
conductivity. If the water
conductivity is less than 150 µS, the
following programmable function will
need to be activated.
Important. This programmable
function should not be activated if,
despite the water being extremely
soft (as would be the case if a water
softener were used), its conductivity
is greater than 150 µS.
Follow steps A to F to programme
and store in memory.
Before you begin, first ensure that
:
–
The tumble dryer is switched off.
–
The door is closed.
A Press the Start/Stop button and keep
it pressed in whilst carrying out steps
B-C.
B Press the I-On/0-Off button in.
Wait until the indicator light for the
Start/Stop button lights up
constantly ...
C . . . and then release the Start/Stop
button.
D Press the Low temperature button six
times.
–
The Low temperature indicator light
will flash on and off slowly once and
will then flash on and off quickly
twice.
– P and 0 (default setting) will flash
alternately in the display.
The number which appears alternately
in the display with P means:
0 Default setting
i Adjusted for very soft water
(with low conductivity)
(The Automatic indicator light will
also flash)
E Pressing the Start/Stop button
switches from one to the other.
F Switch the dryer off with the
I-On/0-Off button.
The setting you have selected is now
stored in memory. You can change it
again at any time.
Programmable functions
57