Filter
Top Products
External water drain
When drying is in progress, condensed
water is pumped into the condensed
water container through the drain hose
at the back of the dryer.
The condensed water can be drained
directly into a drain if the machine is
installed near a sink or standpipe so
that the condensed water container
does not have to be emptied.
Drain hose length: approx. 3 ft. (1 m)
An extension hose is available as and
optional accessory.
Maximum Drain height: 4 ft. (1.2 m)
Installing the drain hose
Rear dryer top:
^
Unclip the drain hose from the
clamps 1 and 2, and pull it off the
holder, 3.
Rear dryer bottom:
^ The lower clamps, 4, can be opened
to install the drain hose or to feed the
power cable through.
Do not pull or kink the drain hose
as this could damage it!
^ Use the curved guide to prevent the
drain hose from becoming kinked
(see "Front view" illustration).
Draining the condensed water into a
sink
^
Secure the hose carefully, e.g. by
tying the hose to the water tap, to
avoid damage by overflowing water.
Connection to a stand pipe
^
Insert the drain hose into the
Y-adapter of the sink.
Installation
35