Memorex CH4 Washer User Manual


 
Rev: 07/2010 Brush Master™ Chipper/Shredder with 2-Way Feed
10
Heavy Duty Power Equipment
Maintenance and Storage
Item
Before each
use
20 hrs or
every 3
months
50 hrs or
every 3
months
100 hrs or
every 6
months
300 hrs or
every 1
year
Engine Oil (Check) X
Engine Oil (Change) X
Air Cleaner (Check) X
Air Cleaner Wash X
Fuel filter Cup (Clean) X
Spark Plug (Clean) X
Spark Plug (Change) X
Lubricate Release Bracket X
Lubricate Hopper Assembly X
Check Chipper Blade X
Fuel Tank and Filter (Clean) X
Maintenance Schedule
Always stop engine, disconnect spark plug, and
ground against engine before cleaning,
lubricating or doing any kind of maintenance on
your machine.
Maintenance and Storage
1. Never tamper with safety devices. Check their proper
operation regularly.
2. Check bolts and screws for proper tightness at
frequent intervals to keep the machine in safe working
condition. Also, visually inspect machine for any
damage and repair, if needed.
3. Before cleaning, repairing, or inspecting, stop the
engine and make certain the impeller and all moving
parts have stopped. Disconnect the spark plug wire
and ground it against the engine to prevent
unintended starting.
4. Do not change the engine governor settings or
overspeed the engine. The governor controls the
maximum safe operating speed of the engine.
5. Maintain or replace safety and instruction labels, as
necessary.
WARNING
6. Follow this manual for safe loading, unloading,
transporting, and storage of this machine.
7. Never store the machine or fuel container inside
where there is an open flame, spark or pilot light such
as a water heater, furnace, clothes dryer, etc.
8. Always refer to the operator’s manual for proper
instructions on off-season storage.
9. If the fuel tank has to be drained, do this outdoors.
10. Observe proper disposal laws and regulations for
gas, oil, etc. to protect the environment.
If the Chipper Becomes Clogged:
If the discharge area becomes clogged:
 Stop the engine. Disconnect spark plug wire from
spark plug and ground against the engine.
 Remove the large funnel and the clean out the
access hatch on the side of the chipper engine box
(as necessary).
 Reach in and clear the debris causing the blockage.
Reinstall the funnel and the clean out access hatch.
 Connect the spark plug wire and restart.
NOTE: If the blockage is severe, the hammer screen
within the discharge chute can be removed as well,
providing greater access. To accomplish this, remove the
pins and slide the flail screen out of the discharge chute.