Filter
Top Products
than three successive blasts.
•The spray button has to be pressed repeat-
edly to release the first spray.
Vertical steaming
It is possible to iron hanging curtains, items of
clothing on a hanger, etc. To do so, follow the
instructions:
•Select the maximum temperature of the iron,
while turning the temperature regulator of the
iron in a clockwise direction.(Fig 2)
•Move the iron in a top to bottom direction while
pressing the steam control ( B ). Important: for
cotton and linen, its recommended to put the
iron base in contact with the material.
•For other more delicate fibres, it’s recom-
mended to keep the iron base a few centime-
tres away.
Once you have finished using the appliance:
•Select the minimum position (MIN) using the
thermostat control.
•Unplug the appliance to the mains.
•Remove the water from the water tank.
•Clean the appliance
Cleaning
•Disconnect the appliance from the mains and
let it cool before undertaking any cleaning
task.
•Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
•Do not use solvents, or products with an acid
or base pH such as bleach, or abrasive prod-
ucts, for cleaning the appliance.
•Do not submerge the appliance in water or
any other liquid, or place it under a running
tap.
Self-cleaning function:
•It is important to self-clean the appliance at
least once a month to remove calcium and
any other built-up minerals inside the iron.
•Fill the depository to its maximum level, as in-
dicated on “water fill” section.
•Place the iron in a vertical position, plug in to
the mains and select the maximum tempera-
ture.
•Leave the appliance to heat up until the pi-
lot light indicates that it has reached its con-
signed temperature.
•Unplug the appliance and place in the sink.
•Press the self-clean button, and keep it
pressed down.
•Let the water flow out through the steam vents
in the base, while lightly shaking the appli-
ance.
•Release the button after a minute or when the
tank becomes empty.
•Leave the iron in the vertical position until it
has cooled.
Anomalies and repair
•Take the appliance to an authorised technical
support service if problems arise. Do not try to
dismantle or repair without assistance, as this
may be dangerous.
•If the connection to the mains has been dam-
aged, it must be replaced and you should pro-
ceed as you would in the case of damage.
23260_IM.indd 5 2013/08/26 10:06:48 AM