Filter
Top Products
Before You Call
For further assistance contact Maytag Appliances Sales Company, Maytag Customer Assistance:
U.S. 1-800-688-9900 or Canada 1-800-688-2002
U.S. customers using TTY for deaf, hearing impaired or speech impaired, call 1-800-688-2080.
Leaks Water
• Make sure hose connections are tight.
• Make sure end of drain hose is correctly inserted and secured to drain facility.
• Check hose to storage tank.
• Avoid extended soaking – soak for 30 minutes or less.
• Avoid overloading.
Is Noisy
• Be sure washer is leveled properly as outlined in installation manual.
• Weak floors can cause vibration and walking.
• Be sure rubber feet are installed on leveling legs.
• A noise is heard when water starts to drain into the storage tub and when it is returned to the washer. This is
normal.
• A clicking sound may be the LoadSensor™ agitator as it moves the load down through the cleaning zone for
maximum cleaning effectivness. This sound will vary from load to load. This is normal.
• Operating sounds will vary depending on agitation speed.
Fills with the Wrong Temperature Water
• Turn both faucets on fully.
• If equipped with a temperature selector knob, be sure it is set directly on a temperature setting and not
between settings.
• Make sure temperature selection is correct.
• Make sure hoses are connected to correct faucets and inlet connections. Be sure water supply is regulated cor-
rectly. Flush water line before filling washer.
• Check the water heater. It should be set to deliver a minimum 120°F (49°C) hot water at the tap. Also check
water heater capacity and recovery rate.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• Water used from previous loads will be cooler. Select “Hot” for the added water to help maintain desired tem-
perature.
9
Cont.