Filter
Top Products
12
9. Attach other end of long hose to fill valve at bottom of dryer back
panel. Screw on coupling by hand until it is seated on fill valve
connector.
10. Using pliers, tighten the coupling an additional two-thirds turn.
NOTE:
Do not overtighten. Damage to the coupling can result.
11. Check that the water faucets ar
e on.
12. Check for leaks around “Y” connector, faucet, and hoses.
LEVEL DRYER
Check the levelness of the dryer by first placing a level on the top
of the dryer near the console.
Then, by placing a level in the crease on the side of the dryer
between the
top of the dryer and the dryer cabinet, check
the levelness from front to back.
If the dryer is not level, prop up the dryer using a wood block. Use a
wrench to adjust the legs up or down and check again for levelness.
COMPLETE INSTALLATION
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. Ch
eck the dryer’s final location. Be sure the vent is not crushed
or kinked.
5. Ch
eck that the dryer is level. See “Level Dryer.”
6. Remove the blue film
on the console and any tape remaining
on the dryer.
7. Wipe the dr
yer drum interior thoroughly with a damp cloth
to remove any dust.
8. Read the “Dryer Use” section in your Use and Care Guide.
Electric Models Only
9. F
or power supply cord installation, plug into a grounded outlet.
Gas Models Only
:
10. Ch
eck that gas supply is on.
11. Ch
eck for leaks.
All Model
s:
12. Se
lect a Timed Dry heated cycle, and start the dryer. Do not select
the Air Only Temperature setting.
If the dryer will not start, check the following:
■ Controls are set in a running or “On” position.
■ Start button has been pushed firmly.
■ Dryer is plugged into an outlet and/or electrical supply
is connected.
■ Household fuse is intact and tight, or circuit breaker
has not tripped.
■ Dryer door is closed.
This dryer automatically runs an installation diagnostic routine
at the start of its first cycle.
NOTE:
You may notice an odor when the dryer is first heated. This
odor is common when the heating element is first used. The odor
will go away.
REVERSE DOOR SWING
You can change your door swing from a right-side opening
to a left-side opening, if desired.
1. Place a towel or soft cloth on top of dryer or work space
to avoid damaging the surface.
Remove the doo
r assembly
1. Open the d
ryer door.
2. Remove the bottom screw from each of the 2 hinges
that attach dryer door to front panel of dryer.