Filter
Top Products
4
Checking Your Vent
Your dryer must be properly installed and vented to achieve
maximum drying efficiency and shorten drying times. Use the
minimum recommended installation clearances found in the
Installation Instructions. See the Installation Instructions for more
information.
WARNING
Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow these instructions can result in death
or fire.
If the dryer is not properly installed and vented, it will not be
covered under the warranty. Proper venting of your dryer is
important for satisfactory drying results. See the Installation
Instructions for more detail.
NOTE: Service ca
lls caused by improper venting will be paid for by
the customer, whether it was a paid installation or self-installed.
1. Do not use plastic vent or metal foil vent. Use 4" (102 mm) metal
or flexible metal vent. Do not kink or crush flexible metal vent. It
must be completely extended to allow adequate exhaust air to
flow. Check vent after installation. Refer to the Installation
Instructions for proper length requirements of vent.
4"
102 mm
2. Use a 4" (102 mm) exhaust hood.
3. Use the straightest path possible when routing the vent.
Good Better
4. Use clamps to seal all joints. Do not use duct tape, screws, or
other fastening devices that extend into the interior of the vent to
secure vent, which can catch lint.
5. Clean exhaust vent periodically, depending on use, but at least
every 2 years, or when installing your dryer in a new location.
When cleaning is complete, be sure to follow the Installation
Instructions supplied with your dryer for final product check.
DRYER USE
Starting Your Dryer
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Do not dry anything that has ever had anything
flammable on it (even after washing).
Failure to follow these instructions can result in death,
explosion, or fire.
WARNING
Fire Hazard
No washer can completely remove oil.
Do not dry anything that has ever had any type of oil on
it (including cooking oils).
Items containing foam, rubber, or plastic must be dried
on a clothesline or by using an Air Cycle.
Failure to follow these instructions can result in death
or fire.
WARNING: To reduce the risk of fire, electric shock, or injury to
persons, read the IMPORTANT SAFETY INSTRUCTIONS before
operating this appliance.
This booklet covers several different models.
Your dryer may not
have all of the cycles and features described.
Before using your dryer, wipe the dry
er drum with a damp cloth to
remove dust from storing and shipping.
1. Clean lint sc
reen before each load. See “Cleaning the Lint
Screen.”
2. Load clothes loosely
into the dryer and close the door. Do not
pack the dryer. Allow space for clothes to tumble freely.
3. T
urn the Cycle Control knob to the recommended cycle for the
type of load being dried. Use the Energy Preferred Automatic
Setting to dry most heavy to medium-weight fabrics.