Filter
Top Products
4
INSTALLATION INSTRUCTIONS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the
instructions provided with any tools listed here.
Parts supplied
Remove parts package from dryer drum. Check that all parts are included.
4 Leveling legs
NOTE: Do not use leveling legs if installing the dryer on a pedestal.
Parts needed
Check local codes. Check existing electrical supply and venting. See “Electrical
Requirements” and “Venting Requirements” before purchasing parts.
For close-clearance installations between 28.65" (72.77 cm) and 34.15" (86.74 cm), see
“Plan Vent System” section for venting requirements.
Mobile home installations require metal exhaust system hardware available for purchase from
the dealer from whom you purchased your dryer. For further information, please refer to the
“Assistance or Service” section.
Optional Pedestal
Are you placing the dryer on a pedestal? You have the option of purchasing pedestals of
different heights separately for this dryer. You may select a 10" (25.4 cm) pedestal or a
15.5" (39.4 cm) pedestal with a storage drawer. The pedestal will add to the total height of the
dryer for a total height of approximately 46" (116.8 cm) or 51.5" (130.8 cm), respectively.
For a garage installation, you will need to place the 10" (25.4 cm) pedestal at least
9" (22.9 cm) above the
oor. You will need to place the 15.5" (39.4 cm) pedestal at least
3" (7.6 cm) above the oor.
The pedestals are available in several colors.
To order, call the dealer from whom you purchased your dryer or refer to the “Assistance or
Service” section.
Stack Kit
Are you planning to stack your washer and dryer? To do so, you will need to purchase a Stack
Kit. To order, call the dealer from whom you purchased your dryer or refer to the “Assistance
or Service” section. Ask for Part Number 8572546.
Flat-blade screwdriver
#2 Phillips screwdriver
Adjustable wrench that opens to 1"
(2.54 cm) or hex-head socket wrench
(for adjusting dryer feet)
Wire stripper (direct wire installations)
Level
Vent clamps
Caulking gun and compound (for
installing new exhaust vent)
Tin snips (new vent installations)
¼" nut driver or socket wrench
(recommended)
Tape measure
34.15"
(86.74 cm)
Optional pedestal (15.5" [39.4 cm] model shown)
P rebmuN traProloCthgieH latsede
10" (25.4 cm) White MHP1000SQ
10" (25.4 cm) BS0001PHMkcalB
15.5" (39.4 cm) White MHP1500SQ
15.5" (39.4 cm) BS0051PHMkcalB
15.5" (39.4 cm) Pacic Blue MHP1500SK
15.5" (39.4 cm) Ocean Sapphire MHP1500SE