Filter
Top Products
7
Starting Your Washer
Your Maytag Washer is equipped with an “Auto Wake-up”
feature. Press any button or open and close the washer lid, and
the display will illuminate. The washer will automatically shut
down if a cycle is not selected and started right away.
Your Maytag Washer will memorize and save all options
and modiers that have been changed during setting mode
(exceptions apply to options for Super Wash, Rapid Wash,
and Normal cycles. They will default back to factory default
settings.)
Using the Proper Detergent
Use only High Efciency detergents. The package for this type of
detergent will be marked “HE” or “High Efciency.” This wash
system, along with less water, will create too much sudsing
with a regular non-HE detergent. Using regular detergent will
likely result in washer errors, longer cycle times, and reduced
rinsing performance. It may also result in component failures and
noticeable mold or mildew. HE detergents are made to produce
the right amount of suds for the best performance. Follow the
manufacturer’s instructions to determine the amount of detergent
to use. Remember, concentrated detergents such as 2x or higher
will use less detergent based on load size.
1. Place a load of sorted clothes into the washer. See “Laundry
Tips.”
Load evenly to maintain washer balance. Mix large and
small items. Items should move easily through the wash
water.
Load only to the top of the basket as shown. Overloading
can cause poor cleaning. Items need to move easily
through the wash water.
For best performance, load garments in loose heaps evenly
around the basket wall. Do not load above the stainless
steel portion of the basket as shown.
2. Pour measured powdered or liquid HE detergent into the
High Efciency detergent dispenser. Always use the detergent
dispenser, and do not put detergent directly onto clothes in the
washer.
H
i
g
h
E
f
f
i
c
i
e
n
c
y
D
e
t
e
r
g
e
n
t
Use Only
NOTE: If you do not press Start/Pause within 5 minutes of pressing
Power/Cancel, the washer automatically shuts off.
3. Add color-safe bleach (powdered or liquid) to this dispenser,
if needed. Be sure to match powdered color-safe bleach with
powdered detergent or match liquid color-safe bleach with
liquid detergent.
4. Pour measured liquid chlorine bleach into the liquid bleach
dispenser, if needed. Bleach is diluted and automatically
dispensed at the proper time during the wash cycle.
Do not overll. Do not dilute. Do not use more than 1 cup
(250 mL) for a full load. Use less with a smaller load size.
Follow the garment and the chlorine bleach manufacturer’s
directions for proper use.
To avoid spilling, use a cup with a pouring spout. Do not
let bleach splash, drip, or run down into the washer basket.
At the end of the cycle, a small amount of water may be
left in the dispenser. This is normal.
NOTE: Use only liquid chlorine bleach in this dispenser.
5. Pour measured liquid fabric softener into the fabric softener
dispenser, if desired.
If you are using fabric softener, be sure to select Fabric
Softener from the options to assure proper dispensing.
Do not overll. Do not dilute. The dispenser holds 3 oz
(94 mL), or a capful of fabric softener.
Fabric softener is dispensed in a deep rinse when the Fabric
Softener option is selected. If Extra Rinse is selected, the
fabric softener will be dispensed during the nal rinse.
Do not use fabric softener dispensing balls in this washer.
Dispensing balls will not operate correctly with this washer.
Do not spill or drip any fabric softener onto the clothes.
At the end of the cycle, a small amount of water may be left
in the dispenser. This is normal.
NOTE: Use only liquid fabric softener in this dispenser.
Use only HE detergent.
WARNING: To reduce the risk of re, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS
before operating this appliance.
The following is a guide to using your washer. Please refer to specic sections of this manual for more detailed information.
QUICK START GUIDE
NOTE: The panel shown above may be different from that of your model.
OPERATING CONTROLS
POWER/CANCEL - Press POWER/CANCEL to turn the
washer on or off.
Start - Press START/PAUSE to start your washer after a cycle has
been selected. Be sure all desired Modiers and Options
have been selected. The lid must be closed for the washer
to start.
START/PAUSE - Press START/PAUSE to start your washer
after a cycle has been selected. Be sure all desired Modiers
and Options have been selected. Press START/PAUSE once
to unlock the lid and add a garment. Press START/PAUSE to
complete the cycle from where it was stopped. The lid must
be closed for the washer to start. Press POWER/CANCEL to
stop the wash cycle. The washer will then drain and turn off.
Lid Lock - When the Lid Lock status light glows, the washer
lid is locked. The lid must be closed for the washer to Start.
NOTE: You must wait until the Lid Lock Light turns off before
the lid can be opened.
OPTIONS AND MODIFIERS
You can change Options and Modiers anytime
before Start/Pause is pressed.
Press POWER/CANCEL.
Select Wash Cycle.
Select desired OPTIONS and MODIFIERS.
Press START/PAUSE or select DELAY START (on some
models) to start wash at a later time.
Changing cycles after pressing Start:
Press POWER/CANCEL once to cancel the cycle.
The washer will drain
Select desired Wash Cycle.
Select desired OPTIONS and MODIFIERS.
Press START/PAUSE or select DELAY START (on some
models) to start wash at a later time. Washer restarts at the
beginning of the new cycle.
NOTE: An error tone will sound if your selection is unavailable.
DETERGENT USE
Use only High Efciency (HE) detergents.
Using regular detergent will likely result in
wash errors, longer cycle times, and
reduced rinsing performance.
For more information, see “Using the Proper Detergent.”
You can place additional clothing in the wash
when the “Add a Garment” status light is
glowing without sacricing wash
performance, at which time, you can:
Press START/PAUSE once. (Lid Lock light turns off,
then open the lid.)
Add garments. (Close washer lid.)
Press START/PAUSE to restart.
To unlock the lid after the Add a garment period,
Press START/PAUSE once. Pressing POWER/CANCEL
will cancel the wash cycle.
ADD A GARMENT, PAUSING, OR
RESTARTING THE WASHER
STOPPING THE WASHER
You can stop the wash cycle and drain the tub by pressing
the Power/Cancel button once.