Filter
Top Products
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.
• Is the dryer located in a room with temperature below
45°F (7°C)?
Proper operation of dryer cycles requires temperatures above 45°F (7°C).
• Is the dryer located in a closet?
Closet doors must have ventilation openings at the top and bottom of the door. Sides and
front of dryer require a minimum of 1" (2.5 cm) of airspace, and the rear of the dryer
requires 5" (12.7 cm). See the Installation Instructions.
• Has an air dry cycle been selected?
Select the right cycle for tile types of garments being dried.
• Is the load too large and heavy to dry quickly?
Separate tile load to tumble freely.
Cycle time too short
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
• Is the automatic cycle ending early?
The load may not be contacting the sensor strips. [evel the dryer.
Change the dryness level setting on Automatic Cycles. Increasing or decreasing the
dryness level will change the amount of drying time in a cycle.
Lint on load
• Is the lint screen clogged?
lint screen should be cleaned before each load.
Stains on load or drum
• Was dryer fabric softener properly used?
Add dryer fabric softener sheets at the beginning of the cycle. Fabric softener sheets added
to a partially dried load can stain your garments.
[)rum stains are caused by dyes in clothing (usually blue jeans). This will not transfer to
other clothing.
Loads are wrinkled
• Was the load removed from dryer at the end of the cycle?
• Was the dryer overloaded?
[)ry smaller loads that can tumble freely.
Odors
• Have you recently been painting, staining or varnishing in the area where your dryer is
located?
If so, ventilate the area. When the odors or fumes are gone from the area, rewash and dry
the clothing.
• Is the dryer being used for the first time?
The new electric heating dement may have an odor. The odor will be gone after tile first
cycle.