Maytag TDL-0050B-B Washer/Dryer User Manual


  Open as PDF
of 4
 
TDL-0050B-B © 2005 Maytag Services Page 3 of 4
ITDL-0020A-B 9/30/2005
7. Remove pressure switch hose from outer tub. Remove screws from sides and rear of unit around bottom,
connecting cabinet to base. Remove cabinet from base and set aside. Be sure to lay down a protective pad
before removing tub and transmission assembly from base. Remove tub springs using the spring removal
tool; be careful not to let tub and transmission assembly tip over.
8. Be sure to lay down a protective pad before removing tub and transmission assembly from base. Remove
tub and transmission assembly, turn over and lay on protective pad.
9. Remove dust cap, retaining ring, washer, cam, and pulley from bottom of transmission.
10. Remove stator from transmission using Brake Removal Tool 12002012, refer to Service Manual for
disassembly procedures. Remove old snubber from transmission.
11. Be sure to wash hands to remove any dirt or grease before handling new snubber. Clean new snubber with
alcohol before installing. Install new snubber. Insure snubber is centered.
Snubber
Dust cap
Retaining ring
Pulley
Cam
Washer
 previous