Filter
Top Products
7
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with beaded tie strap.
LEVEL WASHER
IMPORTANT: Level washer properly to reduce excess noise
and vibration.
If washer is not level, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts clockwise on feet until they
are about 1/2" (13 mm) from the washer cabinet. Then turn the
leveling foot clockwise to lower the washer or counterclockwise
to raise the washer. Recheck levelness of washer and repeat
as needed.
HELPFUL TIP: You may want to prop up front of washer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer.
With washer in its nal location, place a level on top edges of
washer. Use side seam as a guide to check levelness of sides.
Check levelness of front using lid, as shown. Rock washer
back and forth to make sure all four feet make solid contact
with oor. If washer is level, skip to step 14.
When washer is level, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts counterclockwise on
leveling feet tightly against washer cabinet.
HELPFUL TIP: You may want to prop washer with
wooden block.
13. Check levelness of washer
Place level here
Place level here
14. Adjust leveling feet
Jam nut
15. Tighten leveling feet
Jam nut
Not Level LEVEL Not Level
12. Secure drain hose
Laundry Tub Standpipe Wall