Filter
Top Products
5
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. The parts supplied are in the
washer basket.
Tools needed for connecting the drain hose and water inlet hoses:
Parts supplied:
Tools needed for securing the drain hose and leveling the washer:
Parts supplied:
Alternate Parts
Your installation may require additional parts. For information on ordering, please refer to the
toll-free phone numbers on the front page of the Use and Care Guide.
Location Requirements
Selecting the proper location for your washer improves performance and minimizes noise and
possible washer “walk.”
Your washer can be installed in a basement, laundry room, closet, or recessed area. See
“Drain System.”
IMPORTANT: Do not install or store the washer where it will be exposed to the weather.
Proper installation is your responsibility.
You will need:
■ A water heater set to deliver 120°F (49°C) water to the washer.
■ A grounded electrical outlet located within 4 ft (1.2 m) of where the power cord is
attached to the back of the washer. See “Electrical Requirements.”
■ Hot and cold water faucets located within 3 ft (90 cm) of the hot and cold water fill
valves, and water pressure of 5-100 psi (34.5-690 kPa). Washers with triple dispensers
require 20-100 psi (138-690 kPa) for best performance.
■ A level floor with a maximum slope of 1" (2.5 cm) under entire washer. Installing the
washer on carpeting is not recommended.
■ A sturdy floor to support the washer weight (washer, water and load) of 315 lbs (143 kgs).
Do not store or operate your washer in temperatures at or below 32°F (0°C). Some water can
remain in the washer and can cause damage in low temperatures. See “Washer Care.”
■ Pliers that open to 1⁹⁄₁₆"
(3.95 cm)
■ Flashlight (optional)
A.Drain hose form
B.Inlet hose (2)
C.Flat washer (4)
■ Adjustable or open end
wrench ⁹⁄₁₆" (14 mm)
■ Level
■ Wood block
■ Ruler or measuring tape
A. Beaded tie strap
B.Front leveling feet with nuts (2)
AB
C
A
B
If You Have: You Will Need to Buy:
Laundry tub or standpipe
taller than 96" (2.4 m)
Sump pump system (if not already available)
1" (2.5 cm) diameter
standpipe
1¹⁄₄" (3.2 cm) diameter to 1" (2.5 cm) diameter standpipe
adapter, Part Number 280130
Overhead sewer Standard 20 gal. (76 L) 39" (99 cm) tall drain tub or utility
sink, sump pump and connectors (available from local
plumbing suppliers)
Floor drain Siphon break kit, Part Number 280129; additional drain
hose, Part Number 3357090
Water faucets beyond reach
of fill hoses
2 longer water fill hoses:
6 ft (1.8 m) Part Number 76314,
10 ft (3.0 m) Part Number 350008
Drain hose too short Kit Part Number 280131
Lint clogged drain Drain protector, Part Number 367031