Filter
Top Products
30
6. Check to insure that
ALL setscrews (i.e., basket [tumbler] drive, idler, etc.) are tight.
J. PREOPERATIONAL INSTRUCTIONS
1. COIN MODELS
a. Microprocessor Controller (computer)
1) When the microprocessor controller (computer) is in the ready state, the liquid crystal display
(L.C.D.) screen will display “Ready, Insert $XX.XX (amount) to Start.”
2) Insert coin(s). Once the correct “Amount To Start” has been inserted, the L.C.D. will display
“Select Temperature.”
3) Select temperature by pressing “HI,” “PP,” or “LO.” The cycle will start and the L.C.D. will
display the Dry Cycle selected and the remaining time.
4) The dryer will continue through the drying and cooling cycles, until the vended time has expired.
NOTE: To stop dryer, open main door. Continuation of the cycle will resume only after the door has
been closed and any of the three (3) temperature selection is pressed.
5) Upon completion of drying and cooling cycles, the tone (buzzer) will sound and the dryer will go into
the Anti-Wrinkle mode for 99 minutes, or until the main door has been opened.
IMPORTANT: For more detailed information regarding the microprocessor controller (computer) on
your dryer, refer to the MP User’s manual included with the dryer.
K. SHUTDOWN INSTRUCTIONS
If the dryer is to be shutdown (taken out of service) for a period of time, the following must be performed:
1. Discontinue power to the dryer either at the external disconnect switch or the circuit breaker.
2. Discontinue the heat supply:
a. GAS MODELS...discontinue the gas supply.
1) SHUT OFF external gas supply shutoff valve.